1. |
If they are not already selected, select the following icons: |
2. |
If no Pick Color is selected, Scan2CAD will draw on the raster image in black. |
If you want to draw in any other color, select a Pick Color.
3. |
Choose a pen size using Raster Edit Menu > Pen Type > Pen Width. |
4. |
Click at the first point of the Bezier curve. |
5. |
Click at the next point you want the Bezier curve to pass through. A dash line joins the two points. |
 |
To undo it, right click and select Undo Last Segment. |
 |
To cancel the Bezier curve completely, right click and select Quit. |
6. |
When you finish the Bezier curve, Scan2CAD will draw a curve through the points you have entered. However, in some situations you will want a sharp angle at a point rather than a curve. |
For example, let’s say you are drawing a heart and you have just entered the top middle point:

The top middle point should be sharp.
To make it sharp, right click and select Make Last Point Sharp.
When you finish the Bezier curve, the point will be sharp:

If you do not select Make Last Point Sharp, a curve will be drawn through the point when you finish the Bezier curve:

7. |
Repeat Steps 5 and 6 until you have drawn all the points the Bezier curve must pass through: |

To end the Bezier curve at the last point, select Complete Bezier:

To close the Bezier curve, select Close Bezier:

Scan2CAD automatically closes the Bezier curve.
Click to undo.
|