The following miscellaneous commands are available for use in a Command File.
Used to add notes to the Command File.
Where a command has arguments, remarks must not be placed between the command and its arguments.
Remark can be replaced by * or ;
REMARK Load the raster image floorplan.tif
* Select suitable vectorization settings
* Set suitable OCR settings
; Vectorize the image
; Save the vectors as floorplan.dxf
; Exit Scan2CAD
Minimizes the Scan2CAD window while the Command File is running.
Maximizes the Scan2CAD window while the Command File is running.
The maximized Scan2CAD window may not update completely while the Command File is running. This is normal and is not a cause for concern.
Hides the Scan2CAD window while the Command File is running.
Note that when HideWindow is invoked you will not be able to use the Esc key to cancel Command File operation.
Will emit a beep wherever encountered during the Command line file run.
If HideWindow is invoked, it is not always evident when the Command line file has been completed.
Placing CommandBeep before the Exit command will give an audio indication of completion of the Command line file.
Closes the currently loaded raster file.
Exits the Command File and Scan2CAD – normally used as the last command in the Command File.
If you do not use the Exit command Scan2CAD will not be closed when the Command File has finished running. Its window will be maximized and it will remain active.
Have questions on this topic? Talk to us